Have you recently swapped ECMs on your Detroit Diesel Series 60 11.1L, 12.7L, or 14L? Have you lost your original calibration due to ecm failure or improper programming? Do your truck not start or cant connect to Diagnostic Link? This service will restore your stock factory engine calibration with the correct software version and calibration.

Did you accidentally erase ecm, get stuck in boot mode, or purchase a new or reman detroit ECM without proper calibration or any calibration at all? No problem, all i need to know is your engine serial number, VIN number, axle ratios, transmission type (ex. 13 speed manual, 10 speed manual, super 10, 18 speed manual, automatic, ect...), desired speed limit set (if any), injector calibrations (if you have them), tire size, and any protections you want to change.

This means you truck will be just like it was when detroit programmed it from factory. Will be done remotly by teamviewer, or send your ecm to us and we willl program on bench and verify on live engine. Compatable with Detroit diesel DDECI-VI. 

Requirements for remote flashing:

- Laptop with internet connection

- Compatable RP1210A interface (Nexiq USB Link 1, 2, or 3, Noregon DLA, Inline, Ect..)

- Access to vehicle and for to be present for process to cycle key when asked (wont take more than 30 min to complete)

For shipping to us to flash buyer pays shipping to us. Once delievered please allow 2 buisness days before ecm will be sent back. For any questions or information please contact us by phone email or chat.